Harmar Mobility VPL400-X - Troubleshooting

VPL400-X: Install Manual
21JULY2023 | 630-00159 B
32
TROUBLESHOOTING
VPL400-X: SECTION 7
SECTION 7
TROUBLESHOOTING
A BRAKE RELEASE toggle switch is only used during emergency lowering of the platform or positioning the
platform during installation when power is not applied to the unit. See Figure 7-1.
If the brake release switch is enabled, the plaorm
may dri. This should only be used in emergency
lowering situaons or during installaon. Toggle
switch should be ipped "down" during normal
operaon.
WARNING
!
15A BREAKER
The unit has a 15A breaker equipped for the motor
circuit. If tripped, it can be reset to restore normal
function.
2A BREAKER
The unit has a 2A breaker equipped for the interlock
circuit. If tripped, it can be reset to restore normal
function.
Figure 7-2
Figure 7-1