VPL400-X: Install Manual
21JULY2023 | 630-00159 B
9
PREPARATION
VPL400-X: SECTION 3
SECTION 3
PREPARATION
Installations may vary to some degree, but below
are the basic tools to have on hand for a Vertical
Platform Lift installation.
If you have any questions, concerns or comments,
please contact our LiftSquad Support at
800-833-0478 or tech@harmar.com.
REQUIRED TOOLS AND
HARDWARE
• Tape Measure
• Square
• Level
• Multimeter
• Wire Cutters, Wire Puller
• Stripper, Crimping Tool
•
• Wrench Set:
• "
• "
• 5/8"
• "
• "
• Allen Wrench:
• "
• 5/32"
• "
• 7/32"
• "
• Torx Wrench
• T20
• No. 1 Phillips Head Screwdriver
• No. 2 Flat Head Screwdriver
• No. 2 Phillips Head Screwdriver
• Marking Implement
•
socket, extension and ratchet
• Concrete Drill Bits
• Temporary Power Means
• Precision Screwdriver Set
• Yellow / 74B wire Nut
• Anchors for Fixed Ramp (if specified)
RECOMMENDED TOOLS
• Fish Tape
•
• Ladder
• Steel Toe Shoes
• Safety Glasses
• First Aid Kit
• Box Cutter
• Hard Hat
• Shop Vacuum
• Shop Towels and General Purpose Cleaner
BOX REQUIRED
COMPONENTS NOT
SUPPLIED
NOTE: We recommend electrical supply to be installed by
an electrician.
• Indoor applications use 15-amp 120V 2-pole
fusible and lockable disconnect. (NEMA 1) for
outdoor applications use 15-amp 120V 2-pole
fusible and lockable disconnect (NEMA 3R).
• Wire, Conduit and Disconnect to meet NFPA
70 code.
• Dedicated Electrical Lead (per local code).
• Fasteners for top gate and call/send boxes.
To Next Page
Loading...
