Harris HMX6803+ - Page 45

HMX6803+ and OP+HMX+ Installation and Operation Manual 29
Copyright © 2009, Harris Corporation
Chapter 3: Operation
If you attempt to insert audio into Group 1 when Group 1 audio data already
exists in the ancillary data space, an error will be returned, as shown in
Figure 3-3.
Figure 3-3. Append Embedding Mode When Adding Group 1 and a Group 1 Already Exists
If you insert Group 2 audio when there is pre-existing Group 1 audio in the
ancillary data space and no Group 2 audio, the Group 2 audio will be inserted
following the Group 1 audio, as shown in
Figure 3-4.
Figure 3-4. Append Embedding Mode, Adding Group 2 Following Group 1
If you insert Group 1 audio when there is pre-existing Group 2 audio in the
ancillary data space and no Group 1 audio, the Group 1 audio will be inserted
following the Group 2 audio, as shown in
Figure 3-5.
Figure 3-5. Append Embedding Mode, Adding Group 2 Following Group 1
ADS after attempting to embed group 1
ADS before embedding
Pre-existing
Group 1
EAV
EAV
Pre-existing
Group 1
Result: Error is returned
ADS after embedding group 2
EAV Group 1
Group 2
EAV
ADS before embedding
Group 1
ADS before embedding
EAV
Group 2
ADS after embedding group 1
Group 1
EAV
Group 2