Hasselblad H3DII - About Box: Serial Number and Firmware; Resetting to Default Settings

77
MAIN MENU > SETTINGS > About
The About box
Occasionally, Hasselblad releases updates to the internal soware
(“rmware”) of the digital capture unit. ese updates may x
small errors and/or add new features. You will probably receive
additional assistance from Hasselblad technical support if and
when a new update is available. In this case, it may be important
to know the serial number and current rmware vision of your
digital capture unit.
e About box also shows the focus calibration ID (which must
match the information on the grip display under 'System Status'
to obtain the optimum performance). Each digital capture unit
is carefully adjusted to match the corresponding camera body,
which in turn produces the matching verications respectively.
If you want to use dierent digital capture units with dierent
camera bodies, please refer to a Hasselblad Service Center for
more information.
To nd this out:
1. Select MAIN MENU > SETTINGS > ABOUT. (See also
Navigating the Menu System or details about how to nd
this setting.)
2. Press  to open the About dialog, which shows the serial
number and rmware version. When you are done reading
the information, press the menu (EXIT) button to return to the
SETTINGS menu. Either move on to another setting by using
the navigator button or press the menu (EXIT) button again
to exit the menu system.
MAIN MENU > SETTINGS > Default
e DEFAULT setting will reset all custom settings you have made
back to the original default / factory settings.
To reset all settings:
1. Select the MAIN MENU > SETTINGS > DEFAULT entry.
2. Press the OK button and then the EXIT to return.


2


1
1
2