Hasselblad H4D 40 - Using Prof Iles

45
H4D
1
2
3
1 2
3 4
To use a pro le from the main screen, press the PROFILES but-
ton to reach the pro les screen again. Scroll down the list to the
pro le you want and then press the Load (AF) button. All the
saved settings will then be automatically implemented.
If you decided to change the settings but nevertheless keep
the Pro le name on the list, the new set of parameters will be
retained under that name. That is to say, the settings will not
be the same as listed here, despite the name. It might be safer
practice to always change the pro le name to avoid later con-
fusion.
Usingproles
1) From the main screen, click PROFILES (ON.OFF button) on
the grip and the pro le screen will appear.
2) Use the scroll bar to go through the list and highlight the
desired pro le.
3) Press Load (AF button). The camera is now set according to
all the parameters stored according to the name.
Changingaprolename
You can change a pro le name (except ‘Standard’) at any time.
Proceed as follows:
1) From the main screen, click PROFILES (ON.OFF button) on
the grip and the pro le screen will appear.
2) Use the scroll bar to go through the list and highlight the
desired pro le.
3) Press Load (AF button).
4) Click PROFILES (ON.OFF button) again.
5) Press Save (ISO/WB button) The Pro le name screen is then
displayed where you can rename the pro le to what suits you
(see section Image Info 4.2 further on in this manual for pro-
cedure details).
ON•OFF
PROFILES/ESC
ON•OFF
PROFILES/ESC
5
ISO / WB
Save
To quickly reset all pro les back to
the original factory settings:
1. Remove battery.
2. Wait 510 seconds.
3. Replace the battery while keep-
ing both the Menu and IS0/WB
buttons pressed.
MENU
ISO/WB
ON•OFF
PROFILES/ESC
Note
AF
Load
AF
Load