Hasselblad H6D - Remove; Attach Viewfinder

5.27 REMOVE / ATTACH VIEWFINDER
REMOVE THE VIEWFINDER
Caution!
Be careful when you attach/detach the components to/from
the camera. This will help prevent damage to the data bus
connections.
Caution!
Use the grip or strap when you lift and handle to camera. This
will help prevent damage to the camera.
1 Hold the Viewnder in your right hand.
2 Press and hold down the Viewnder release button (A).
3 Lift the rear of the Viewnder up and away from the camera
body.
ATTACH THE VIEWFINDER
Caution!
Be careful when you attach/detach the components to/from
the camera. This will help prevent damage to the data bus
connections.
Caution!
Use the grip or strap when you lift and handle to camera. This
will help prevent damage to the camera.
1 Hold the Viewnder at a slight angle and rest it on the top of
the camera.
2 Slide the Viewnder forward until the front locating pin is
in position in the recess in the front edge of the viewnder
screen aperture (B) on camera body.
3 Press the rear part of the Viewnder rmly downwards until it
clicks into place.
4 Make sure that both sides of the Viewnder are seated
correctly and that it has been rmly attached and locked into
position.
H6D www.hasselblad.com
USER GUIDE
To Use
150
A
B