Hasselblad H6D - Access to Flash Controls

ACCESS TO FLASH CONTROLS
1 Activate the camera and press the + / - button on the
Viewnder once.
2 Turn the Front scroll wheel (1) to set the amount of
compensation required from +3 EV through -3 EV.
3 Turn the Rear Scroll Wheel (2) to set whether the ash is
triggered just after the shutter opens or just before the
shutter closes go to Camera Settings/Exposure/Flash and
set Sync to Normal or Rear.
4 To set Flash Measure program a button in Camera Settings/
Controls to “Flash Measure”. Then trigger Flash Measure
using this button. A specic screen on the grip display
request you to press the AE-L button in order to make a
reading.
5 When set to Flash Measure, a specic screen requests you
to press the AE-L button in order to make a reading.
H6D www.hasselblad.com
USER GUIDE
To Use
95
1
2
1 Front Scroll Wheel
2 Rear Scroll Wheel