Hasselblad H6D - Integral Flash

INTEGRAL FLASH
The integral ash unit features the following specications:
Guide no. 12
Coverage 56º horizontal, 44º vertical
Maximum light fall-off at side centres - 1EV (50%)
Colour temperature (full ash) 5,000 – 5,600º K
To raise the ash unit into its operative position, slide the ash-
back catch backwards in the direction of the ash symbol. To
return the ash unit into its closed position, push down on the
top of the back until it clicks back into place. The ash unit is
automatically activated when it is in the operative position and
de-activated when returned to its stored position.
The green LED ash symbol blinks in the viewnder when the
ash unit is charging and remains stationary when fully charged.
The ash output can also be adjusted for optimum light balance
in ll-ash situations.
Using the integral ash:
1 Slide the ash-back catch backwards in the direction of the
ash symbol.
2 On the Camera Sensor Unit Display select Camera >
Exposure and scroll down to Flash..
3 Choose between Normal or Rear sync.
4 Exit the Main Menu to Save and make an exposure.
5 If the settings were incorrect to match the output of the ash
unit, the viewnder display shows a red triangle alongside a
ashing green ‘ash’ symbol plus a warning message - ‘Low
ash’. The grip display will also show a warning message -
‘Low ash’.
Conventional measures should then be taken to correct
the situation, move closer to the main subject, use a larger
aperture setting or use a higher ISO setting.
Note!
Do not use the integral ash together when another external TTL
ash unit is connected (and used in TTL or A mode).
Note!
For full coverage with the integral ash, use 80mm or longer
lenses (without a lens shade).
H6D www.hasselblad.com
USER GUIDE
To Use
96
1 Integral ash
2 Integral ash release
1
2