HDL KNX / EIB Switch Actuators
_____________________________________________________________________________________
Guangzhou Hedong Electronic Co.,Ltd (HDL)
www.hdlchina.com 40/58
This parameter is set ON counter overflow alarm interval.
Options: 1..255s
>>:--Alarm telegram number(1..255,0-unlimited)
This parameter set the ON counter overflow alarm number.
Options:0-unlimited
1..255
---PWM cycle time set (1...65535) min
Options:1…65535m
This cycle time is set Minimum is 1 minutes
---PWM cycle time set (0...59) sec
Options:0..59s
This cycle time is set in seconds
---Control telegram is received as
Type of control can be control as 1bit or 1byte.
Options: 1bit PWM(1-start/0-stop)
1byte(255-switch ON/0-switch OFF/ other valve)
1bit PWM(1-start/0-stop): The PWM start and switch ON by the
value of receiving telegram “1” , and stop by “0”.
1byte(255-ON/0-OFF/other valve): the switch ON always by the
value of receiving telegram “255”, the switch OFF by the value of
receiving telegram “0”. The PWM runs and pulse width of PWM is set
according to the value of receiving telegram (1 to 254 )
---transmit status response object "telegram: status heating"
It has three option for the channel state response setting
Options: No response
Always response
Only after changed
No response: no response switch state.
Always response: always response switch state of the channel when
receive the channel telegram data.
Only after changed: only response switch state of the channel when
change state changed.
---"ON" position of valve
To Next Page
Loading...