HDL KNX / EIB Switch Actuators
_____________________________________________________________________________________
Guangzhou Hedong Electronic Co.,Ltd (HDL)
www.hdlchina.com 7/58
Note: in some of application need ON/OFF the relay frequently and not allow too much
delay time, in that case it can be connected a additional 24-30VDC power supply,
the Max. current is requested 24mA when the relay is active ,the standby current is
requested 4mA , the delay time is approx 100ms on switch state change when the
charge of the capacity is not enough
Connections
* EIB / KNX Bus Connection Terminal
0.8 mm Ø, single core
* Load circuits Screw terminal with Slotted head
0.2...4 mm² multi- core
0.4...6 mm² single-core
* cable shoe 12 mm
* Tightening torque Max. 0.8 Nm
Operating and display
* Red LED and EIB / KNX push button all in one
For assignment of the physical address
* Contact position indication Relay lever
Temperature range
* Operation – 5 °C ~ + 45 °C
* Storage – 25 °C ~ + 55 °C
* Transport – 25 °C ~ + 70 °C
Environment conditions
* humidity max. 95 % Non-condensing
Appearance design
* Modular DIN-Rail Modular installation
* Type–M/R 4.16.1 8.16.1 12.16.1
* Dimensions (H x W x D) 90 x W x 64
* Width W (unit mm) 72 144 216
* Mounting width (1P=18 mm) 4P 8P 12P
* Mounting depth (unit mm) 64 64 64
Weight (unit kg) 0.26 0.49 0.72
Installation Use 35 mm mounting rail
Mounting position Electric switch box
Material and Colour Plastic, grey
Standard and Safety Certificated
* LVD Standard EN60669-2-1 , EN60669-1
*EMC Standard EN50090-2-2
CE mark
* In accordance with the EMC guideline and low voltage guideline
Pollutant Comply with RoHS
Note: All of loads, at 230 V AC
To Next Page
Loading...