35
(4.6.4) Ext Amp
You can assign a switch to send a signal to your traditional guitar amplifier’s footswitch input by using the external
amp output. You can use this feature to do things like change from the clean to dirty channel or turn reverb on and
off on your amplifier.
To use this feature when switching to a rig, tap the button under Ext Amp on the hardware assign page, and then
select Tip, Ring, or Both. If you are unsure of which setting to use, please consult the amplifier's manual or
manufacturer to confirm.
This feature can also be assigned to a footswitch on the Model Selector page that appears when you are assigning
a footswitch’s function. It can also be assigned to a scene by adjusting the parameter on the Scene Editor screen.
IMPORTANT! Only connect this output to amplifiers that have a "short-to-sleeve" footswitch input. If you connect
this output to any other type of footswitch input, you may cause permanent damage to your equipment. If you are
unsure if your amplifier has a “short-to-sleeve” footswitch input, please consult the amplifier’s manual or
manufacturer to confirm.
To Next Page
Loading...
