62
(4.21) External MIDI Control
HeadRush Core can be controlled by incoming MIDI CC (control change) messages sent by external MIDI gear.
This external MIDI gear must be connected to the 5-pin MIDI Input or the USB-A connection. If USB-MIDI gear is
being connected to the USB-A port, it must be class compliant and require no software drivers to function.
The chart below lists the parameters that can be controlled by external MIDI hardware:
CC# Action CC# Action
01 Expression Pedal 81 Block 7 Toggle ON/OFF
49 Footswitch 1 82 Block 8 Toggle ON/OFF
50 Footswitch 2 83 Block 9 Toggle ON/OFF
51 Footswitch 3 84 Block 10 Toggle ON/OFF
52 Footswitch 4 85 Block 11 Toggle ON/OFF
53 Footswitch 5 86 Block 12 Toggle ON/OFF
64 Tap Tempo 87 Block 13 Toggle ON/OFF
65 Looper 1/2 Speed 88 Block 14 Toggle ON/OFF
66 Looper 2X Speed 89 Toggle MIC Dry Out ON/OFF
67 Looper 1/2 Loop 102 Practice Tool – Open
68 Looper 2X Loop 103 Practice Tool – Play
69 Looper Start/Stop 104 Practice Tool – Volume Down
70 Looper Record 105 Practice Tool – Volume Up
71 Looper Insert 106 Practice Tool – Loop In
72 Looper Peel 107 Practice Tool – Loop Out
73 Looper Mute 108 Practice Tool – Speed Down
74 Looper Reverse 109 Practice Tool – Speed Up
75 Block 1 Toggle ON/OFF 110 Practice Tool – Pitch Down
76 Block 2 Toggle ON/OFF 111 Practice Tool – Pitch Up
77 Block 3 Toggle ON/OFF 112 Practice Tool – Previous
78 Block 4 Toggle ON/OFF 113 Practice Tool – Next
79 Block 5 Toggle ON/OFF 114 Practice Tool – Loop On/Off
80 Block 6 Toggle ON/OFF 115 Metronome On
To Next Page
Loading...
