60
(4.20.5) USB Audio
USB Audio: This setting determines whether or not HeadRush
Core is sending a USB audio signal over a USB connection.
Tap On to enable sending of the USB audio signal with the
selected Sample Rate. Tap Off to disable the USB audio
signal. To change the Sample Rate, set USB Audio to Off
first, select the correct sample rate, set USB Audio to On
again, and restart your DAW.
Sample Rate: This setting determines the sample rate of the
USB audio signal: 44.1 kHz, 48.0 kHz, or 96.0 kHz. Remember
to select the same sample rate as the one in your DAW. Also,
set it before opening your DAW.
USB Mode: This setting determines what audio signal HeadRush Core sends over the USB connection and how
its outputs function while doing so:
• Live: The audio signal will be sent to your computer as well as to HeadRush Core’s outputs.
• DAW: The audio signal will be sent to your computer only. HeadRush Core’s outputs will be disabled to
prevent any latency while monitoring.
• Reamp: Your computer will send an audio signal to HeadRush Core, which will process it through the current
rig and send it back to your computer. HeadRush Core’s outputs will be disabled to prevent any latency while
monitoring. See (4.15.3) USB > Reamping to learn how to configure your DAW for this process.
USB In Level: This setting determines the incoming USB Audio level, from -60.0 dB to 12.0 dB.
(4.20.6) MIDI
These settings determine how HeadRush Core sends and
receives MIDI information to and from external devices. These
settings affect only HeadRush Core’s MIDI Input and MIDI
Output.
MIDI Thru: Tap On to use the MIDI Output as a MIDI
throughput; any MIDI information sent to HeadRush Core’s
MIDI Input will be sent directly to the MIDI Output. Tap Off
to use HeadRush Core’s MIDI output normally; HeadRush
Core will be able to send its own MIDI information out of
the MIDI output.
Receive MIDI Clock: Tap On to enable HeadRush Core to
receive MIDI clock information. Tap Off to use HeadRush
Core’s own internal MIDI clock (which will not be sent out).
Prog Change: Tap Send to enable or disable HeadRush
Core’s transmission of MIDI program change messages
when you load a rig. Tap Recv to enable or disable
HeadRush Core’s reception of MIDI program change
messages from an external MIDI device.
MIDI Channel: This setting determines the MIDI channel(s)
from which HeadRush Core will send and receive MIDI
messages. Tap this field, turn the encoder to select all
channels (Omni), or 1–16, and then press the encoder.
To Next Page
Loading...
