22
Impulse Response (2048 / 1024)
An Impulse Response (IR) is a popular alternative to
traditional guitar cabinet models, typically stored as a .WAV
file. Flex Prime includes over 300 Impulse Responses
onboard; however, there are also many reputable third-
party companies, producers, and artists that capture and
distribute impulse responses that can be imported into Flex
Prime.
If you are loading an impulse response (IR) file, you can do
so at the highest quality (2048 samples) or choose to load
at a lower quality (truncated to 1024 samples), which is less
DSP-intensive, freeing up more resources to load and use
additional blocks and/or IRs to your rigs.
Preset: This is the current IR preset, which includes the selected IR, all its settings, and its color assignment.
IR File: Tap here to select an IR file from your internal storage.
IR Settings: After the IR has been selected, you can further dial in the IR’s sound by adjusting the Gain, Hi-
Cut, Lo-Cut, and Mix parameters on screen.
Amp and Pedal Clones
A Clone is an alternative type of guitar/bass amplifier or
distortion/overdrive/fuzz pedal simulation that allows you to
capture the sound of your own gear and use it inside of Flex
Prime. Amp and Pedal clones may be downloaded from the
(4.14) HeadRush Cloud.
Preset: This is the current Clone preset, which includes
the selected clone, all its settings, and its color
assignment.
Clone File: Tap here to select a previously created or
imported clone from your internal storage.
Clone Settings: After the Clone has been selected, you
can further dial in the clone’s sound by adjusting the
tone stack parameters that appear on screen.
Cab ON/OFF: You can use this setting to disable to
sound of the speaker cab from your Amp & Cab clone,
and instead use an onboard cabinet model or an IR
file.
To Next Page
Loading...
