26
(4.5) Footswitch Modes
The three footswitches can be used to activate or bypass blocks
(amps, cabs, impulse responses, or effects) as well as select
scenes, rigs, or setlists. These footswitches are always in one of
four modes: Stomp, Rig, Hybrid, or Setlist.
To change the mode, hold footswitch 1, then:
• To select Stomp mode, press footswitch 1.
• To select Rig mode, press footswitch 2.
• To select Setlist mode, hold footswitch 2.
• To select Hybrid mode, press footswitch 3.
In addition to the four main footswitch modes, you can also access the following options after holding footswitch 1:
• To open Hands Free mode, hold footswitch 1 again. See (4.7) Hands Free Mode for more details.
• To lock or unlock the screen, hold footswitch 3. See (4.16) Lock Screen for more details.
(4.5.1) Stomp Mode
Footswitches 1-3 correspond to blocks (amps, cabs, or effects) in
your signal chain. Use (4.6) Hardware Assign
mode to assign
blocks to the footswitches.
Press a footswitch to activate or deactivate its block.
To load the previous rig, press footswitches 1 and 2 ()
simultaneously.
To load the next rig, press footswitches 2 and 3 ()
simultaneously.
(4.5.2) Rig Mode
Footswitches 1-3 correspond to rigs you have previously saved.
Press a footswitch to load its rig. See (4.3) Rigs to learn more
about rigs.
To show the previous bank of three rigs, press
footswitches 1 and 2 () simultaneously.
To show the next bank of three rigs, press footswitches 2
and 3 () simultaneously.
To Next Page
Loading...
