13
(4.3.2) Signal Path
The signal path is the direction that the audio signal follows from your guitar, through
your 14 available slots, and ends at the outputs of Flex Prime. You can easily reconfigure
your signal path to best suit your needs, especially when it comes to creating more
complex rigs.
To reconfigure the signal path, tap the signal path icon at the top-right corner of the
main screen.
The following signal path options are available:
Straight Path
This straight signal path is the default and the most common for
users that are creating non-complex guitar tones.
Middle Split
This signal path splits in the middle and rejoins near the end.
This configuration is useful for using two types of effects (or
chains of effects) but want to keep their signals separate.
There are three separate Middle Split options:
• Middle Split 3-4-3 features three slots after the Input, an
eight-slot split Mix section, and then three slots before the
Output.
• Middle Split 5-3-3 features five slots after the Input, a six-
slot split Mix section, and then three slots before the Output.
Note: Middle Splits 3-4-3 and 5-3-3 use the same singal
path icon shape.
• Middle Split 7-2-3 features seven slots after the Input, a
two-slot split Mix section, and then three slots before the
Output.
See (4.4.2) Adjusting Settings > Parameters > Mix to learn
how to mix the split paths together.
To Next Page
Loading...
