Machine mode of operation | Machine data
4
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
105
Elements of machine data display
Display of quantity: The quantity is incremented after each M30, M99 or M18
programmed counter pulse
MP: Defined quantity
P: Number of finished parts
Display of quantity and job time: The quantity is incremented after each
M30, M99 or M18 programmed counter pulse
MP: Defined quantity
P: Number of finished parts
t: Run time of the current program
Sum t: Total time
Display of skip levels and M01 conditional stop:
Defined skip levels (upper row) and set or activated skip levels (lower row)
Setting for M01: M01 is not executed in Continuous run mode (yellow
display)
Load monitoring display:
Left field: zone number (here: 345)
Right fields: monitored axes (max. 4)
Display of rear-face machining: Information about rear-face machining is
shown in the RSM display (RSM: Rear Side Machining)
RSM status
Active datum shift of the configured RSM axis
B-axis display: The information displayed about the status of the tilted plane
varies depending on the setting of the machine parameters
Programmed angular value of the B axis
Display of the current values I, K, U and W
I: Plane reference in X
K: Plane reference in Z
U: Shift in X
W: Shift in Z
Date and time display
Display of an integrated logo
To Next Page
Loading...
