ICP programming | Lateral surface contours in smart.Turn mode of operation
6
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
485
6.13
Lateral surface contours in smart.Turn
mode of operation
In smart.Turn mode of operation, ICP provides the following
contours for machining with the C axis:
Complex contours defined with individual contour elements
Figures
Holes
Pattern of figures or holes
Reference data of lateral surface
The reference data is followed by the contour definition with
individual contour elements.
Further information: "Contour elements on lateral surface",
Page 465
Reference data of lateral surface:
ID: Contour
PT: Milling depth
XR: Reference diameter
You can use the Select reference plane function to determine
the Reference diameter XR. The reference diameter is used for
converting angle dimensions into linear dimensions.
"Reference data and nested contours"
ICP generates the following:
The LATERAL section code with the Reference diameter
parameter. In nested contours, ICP generates only one section
code
A G308 with the Contour name and Milling depth parameters
A G309 at the end of the contour description or after the figure
To Next Page
Loading...
