ICP programming | Editing ICP contours
6
440
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Editing or deleting the last contour element
Editing the last contour element: When the Change last soft key
is pressed, the data of the last contour element are presented for
editing.
Depending on the adjoining contour elements, corrections of linear
or circular elements are either transferred immediately or the
corrected contour is displayed for inspection. ICP highlights the
affected contour elements in color. If there are several possible
solutions, you can check all mathematically possible solutions with
the next solution and previous solution soft keys.
The change will not become effective until you confirm by soft key.
If you discard the change, the old description becomes effective
again.
The type of contour element (linear or circular element), the
direction of a linear element, or the direction of rotation of a circular
element cannot be changed. Should this be necessary, you must
delete the element and add a new contour element.
Deleting the last contour element: When the Delete last soft
key is pressed, the data of the last contour element are discarded.
You can use this function repeatedly to delete several successive
contour elements.
Deleting contour elements
Deleting a contour element:
Select the Manipulate menu item
The menu displays functions for trimming,
editing and deleting contours
Select the Delete menu item
Select the Element/range menu item
Select the contour element to be deleted
Delete the contour element
You can delete several successive contour elements.
To Next Page
Loading...
