HEIDENHAIN 548431-05 - Program Run Submode; Loading a Program

Machine mode of operation | Program run submode
4
142
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
4.9 Program run submode
Loading a program
In Program run submode, you use Teach-in programs, DIN
programs or automatic jobs for parts production. You cannot
change the programs in this mode. The Simulation submode,
however, allows you to check the programs before you run them.
The control also offers the Single block and the Continuous
run mode with which you can machine step by step the first
workpiece of a whole batch.
The smart.Turn programs are saved as DIN programs (*.nc).
Automatic jobs (*.job) are also generated in smart.Turn mode of
operation.
By default, Program run submode automatically loads the most
recently used program. Use machine parameter 601814 to specify
that the program will not be selected automatically.
To load another program, proceed as follows:
Press the Program list soft key
The control displays the teach-in programs.
Alternative: Display the DIN program
Select the Teach-in program or DIN program
Press the Open soft key
You can start a Teach-in or smart.Turn program at any desired block
to resume a machining operation after an interruption (Start blck
search).
The Program run submode can be switched on by soft key and is
displayed in the header.
Further information: "Program management", Page 164
Programs selected in Program run submode are
protected from deletion.
To enable the file for deletion, exit the program block
display by pressing the Back soft key.