HEIDENHAIN 548431-05 - ICP Editor Submode in Smart.turn Mode of Operation

ICP programming | ICP editor submode in smart.Turn mode of operation
6
422
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
6.3
ICP editor submode in smart.Turn mode
of operation
In smart.Turn mode of operation you create:
Contour groups
Workpiece blank contours and auxiliary workpiece blank
contours
Finished part contours and auxiliary contours
Standard figures and complex contours for C-axis machining
on the face
on the lateral surface
Standard figures and complex contours for Y-axis machining
on the XY plane
on the YZ plane
Contour groups: The control supports up to four contour groups
(BLANK, FINISHED PART and TEMPORARY) in one NC program. The
Contour group section code initiates the description of a contour
group.
Further information: "Contour groups", Page 528
Workpiece blank contours and auxiliary workpiece blank
contours: You describe complex workpiece blanks element by
element—like finished parts. You select the standard forms of bar
and tube by menu and describe them with a few parameters. If a
definition of the finished part exists, you can also select Cast part in
the menu.
Further information: "Workpiece blank definition", Page 448
Figures and patterns for C and Y axis machining: You describe
complex milling contours element by element. The following
standard figures are prepared.
You select the figures by menu and describe them with a few
parameters:
Circle
Rectangle
Polygon C
Linear slot
Circular slot
Hole
You can arrange these figures and holes as linear or circular
patterns on the face or lateral surface as well as in the XY or YZ
plane.
You can import DXF contours and integrate them in the smart.Turn
program.