ICP programming | ICP editor submode in smart.Turn mode of operation
6
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
423
Cycle programming contours can be loaded and integrated into
the smart.Turn program.
The smart.Turn operating mode supports loading the following
contours:
Workpiece blank description (extension *.gmr): Loaded as
workpiece blank contour or auxiliary workpiece blank contour
Contour for turning (extension *.gmi): Loaded as finished part
contour or auxiliary contour
Face contour (extension *.gms)
Lateral surface contour (extension *.gmm)
ICP uses G codes to describe the contours created in
the smart.Turn program.
In the convertICP (602023) machine parameter, you
define whether the control loads the programmed or
calculated values into the NC program.
To Next Page
Loading...
