Teach-in | Milling cycles
5
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
361
5.8 Milling cycles
Menu item Meaning
Milling cycles are used to machine axial and
radial slots, contours, pockets, surfaces and
polygons.
Pattern machining:
Further information: "Drilling and milling patterns", Page 398
In Teach-in submode these cycles include the activation/
deactivation of the C axis and the positioning of the spindle.
In Machine mode you can activate the C axis with Rapid
positioning and position the spindle before the actual milling cycle.
The milling cycles then automatically deactivate the C axis.
Menu item Milling cycles
Rapid positioning
Activate C axis; position tool and spindle
Slot axial/Slot radial
For milling single slots or slot patterns
Figure axial/Figure radial
For milling a single figure
ICP contour axial/ICP contour radial
For milling single ICP contours or contour
patterns
Face milling
For milling surfaces or polygons
Hel. groove millg. radial
Radial milling for machining a helical slot
Engraving, axial/Engraving, radial
Engraves characters and character strings
To Next Page
Loading...
