Graphic simulation | Views
7
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
541
3-D view
Soft key Meaning
The 3-D view menu item switches
to a perspective view and shows the
programmed finished part
With the 3-D view, you can display the workpiece blank and the
finished part with all turning operations, milling contours, drilling
and boring operations as well as threads in a solid-model view.
Tilted Y planes and machining operations referenced to them, such
as pockets or patterns, are also displayed correctly by the control.
The control displays milling contours depending on the HC: Milling/
drilling attribute parameter from G308. If you have selected
the contour milling, pocket milling or area milling values in this
parameter, the graphic shows the respective 3-D elements. If other
values are specified in the HC parameter or if values are missing,
the control depicts the described milling contour as a blue line.
Each element that cannot be calculated by the control is displayed
as an orange line; for example, if an open milling contour is
programmed as a pocket. With the soft keys and the menu
functions, you can influence the display of the workpiece.
The finished part contour programmed in the FINISHED
section is shown in the graphic regardless of the
machining operation in the NC program.
You can cancel the calculation of the 3-D view by
pressing the ESC key or the CANCEL soft key.
Check mode
The check mode enables you to verify the correct positioning of
holes and milling contours, for example.
In the check mode the control displays turning contours in gray, and
drilling and milling contours in yellow. For a better overview, the
control shows all contours as transparent.
To Next Page
Loading...
