Machine mode of operation | Pocket table setup
4
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
113
Editing the turret list
The turret assignment list indicates the current assignment of the
tool carrier. When you set up a turret list, you enter the ID numbers
of the tools.
The turret list can be set up through the TSF menu or directly from
the cycle dialogs in Teach-in submode. The desired turret pocket is
selected with the arrow keys.
You can also set up manual changing systems in the turret
assignment list.
Further information: "Setting up the holder for manual change
systems", Page 574
Setting up the turret list:
Select Set T, S, F (can only be selected in
Machine mode of operation)
Alternative: Initiate the cycle dialog
Press the Turret list soft key to activate the
turret assignment list and the tool list
Use the arrow keys to select a turret pocket
Adapt the turret assignment list with the soft
keys
Alternative: Enter the tool ID number directly
Entering the tool ID number directly:
Press the ENT key to activate direct input
Enter the tool ID number
Press the INS key to conclude input
Alternative: Press the ESC key to cancel input
To Next Page
Loading...
