Machine mode of operation | Pocket table setup
4
114
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Soft keys in turret list
Delete entry
Paste entry from clipboard
Cut out entry and save it in the clipboard
Show entries in the tool database
Switch to next menu
This soft key is available once you press the
Special functions soft key.
Delete the complete turret list
This soft key is available once you press the
Special functions soft key.
Reset tool life
This soft key is available once you press the
Special functions soft key.
Switches the tool parameter view
This soft key is available once you press the
Special functions soft key.
Opens the Table of the tool holder
This soft key is available once you press the
Special functions soft key.
Deletes the tool holder from the turret assign-
ment list
Back by one menu level
Load the tool number and the tool ID number
into the TSF or cycle dialog
Close the turret list without loading the tool
number and tool ID number into the dialog.
Changes to the turret list are retained
To Next Page
Loading...
