Tool and technology database | Tool data
8
584
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Centering tool
Press the New tool soft key
Press the Special tool soft key
Press the special drilling tools soft key
Press the Center drill soft key
The help graphics illustrate the dimensions of the tools.
Special parameters for centering tools:
DV: Hole diameter
DH: Stud diameter
BW: Drill angle – Point angle of the drill
SW: Point angle
ZA: Stud length
Further tool parameters:
Further information: "General tool parameters", Page 576
For drilling operations at constant cutting speed, the
Hole diameter DV parameter is used to calculate the
spindle speed.
To Next Page
Loading...
