Teach-in | Single cut cycles
5
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
185
Approaching the tool change position
Select Single cuts
Select Rap. trav. positioning
Press the T-Change approach soft key
The tool moves at rapid traverse from the current position to the
Tool change point.
Further information: "Tool change point G14", Page 180
After reaching the tool change point, the control switches to the
tool indicated in T.
Cycle parameters:
G14: Tool change point – Sequence (default: 0)
0: Simultaneously (diagonal path of traverse)
1: First X, then Z
2: First Z, then X
3: Only X
4: Only Z
5: Only Y (machine-dependent)
6: Simultaneous w/ Y (machine-dependent)
T: Tool number – turret pocket number
ID: ID no.
MT: M after T: M function that is executed after the tool call T
MFS: M at beginning: M function that is executed at the
beginning of the machining step
MFE: M at end: M function that is executed at the end of the
machining step
WP: No. of spindle – Displays which workpiece spindle is used
to execute the cycle (machine-dependent)
Main drive
Opposing spindle for rear-face machining
BW: Angle in the B axis (machine-dependent)
CW: Reverse the tool (machine-dependent)
HC: Shoe brake (machine-dependent)
DF: Miscellaneous function (machine-dependent)
To Next Page
Loading...
