Graphic simulation | Simulation window
7
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
535
7.2 Simulation window
Setting up the views
With the simulation windows described in the following you check
not only the turning operation but also the drilling and milling
operations.
XZ view (turning view): The turning contour is depicted in the
XZ coordinate system. The configured coordinate system is
taken into account (tool carrier in front of/behind the workpiece,
vertical lathes)
XC view (face view): The displayed coordinate system is a
Cartesian system with the axis designations XK (horizontal) and
YK (vertical). The angle position C = 0° is on the XK axis, the
positive direction of rotation is counterclockwise
ZC view (lateral surface view): The contour display and
traverse-path display are oriented to the position on the
unrolled lateral surface and the Z coordinates. The upper
and lower lines of this workpiece correspond to the angular
positions C = –180°/+180°, respectively. All drilling and milling
operations are within the range –180° to +180°
Cycle program or DIN program with workpiece blank
definition: The basis for the unrolled workpiece surface is
the dimensions of the programmed workpiece blank
Cycle program or DIN program without workpiece blank
definition: The unrolled workpiece surface is based on the
dimensions of the standard workpiece blank
CfgSimWindowSize (115200) machine parameter
Single cycle or Teach-in: The basis of the unrolled
workpiece surface is the workpiece section defined by the
respective cycle (expansion in Z and Limit diameter X)
YZ view (side view): The contour and the traverse path are
shown in the YZ plane. The side view depicts only the Y and Z
coordinates—not the spindle position
Front face and surface windows operate with a fixed
spindle position. Whereas the machine turns the
workpiece, the Simulation submode moves the tool.
Simulation of multiple contour groups
Please note the following when working with multiple contour
groups:
In the XZ view (turning view), the control displays all contour
groups.
In all other views, the control displays the current contour
group.
To Next Page
Loading...
