Graphic simulation | Simulation submode
7
534
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Miscellaneous functions soft keys
Switch between wire-frame graphics and
cutting-path graphics
Switch between light-dot and cutting-edge
view
Activate the 2-D material-removal graphic
Switch to the next contour group
This soft key is only active if you are working
with multiple contour groups.
Select the view
Display the internally used workpiece blank
for programs without a defined workpiece
blank
Switch the focus to the next window. Only
active for multiple window view
Further information: "Multiple window
view", Page 536
To Next Page
Loading...
