Machine mode of operation | Machine data
4
106
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Cycle states
The control shows the current cycle status with the cycle symbol.
Cycle symbols
Cycle ON status
Cycle or program execution is active
Cycle OFF status
Cycle or program execution is not active
Axis feed rate
F is the identification letter for feed data.
Depending on which mode of the Minute feed soft key is active,
data is entered in:
Millimeters per spindle revolution (feed per revolution)
Millimeters per minute (feed per minute)
On the screen, you can tell the type of feed rate from the unit of
measure in the input field.
You can change the feed value with the feed compensation
controller (feed override) (range: 0 % to 150 %).
To Next Page
Loading...
