Teach-in | Drilling and milling patterns
5
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
407
Circular milling pattern, axial
Select Milling
Select Axial slot
Alternative: Select Axial contour ICP
Press the Pattern circular soft key
Press Pattern circular during milling cycles to machine milling
patterns in which the individual features are arranged at a regular
spacing in a circle or circular arc on the face.
Cycle parameters:
X, Z: Start point
C: Spindle angle – C-axis position (default: current spindle
angle)
Q: Number of slots
XM, CM: Polar center point
XK, YK: Cartesian center point
K: Pattern diameter
A: Angle of 1st slot (default: 0°)
Wi: Angle increment – Pattern spacing (default: milling
operations are arranged at a regular spacing in a circle)
The parameters of the milling operation are also requested.
Use the following parameter combinations to define the:
XM, CM
XK, YK
To Next Page
Loading...
