Machine mode of operation | Pocket table setup
4
116
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Returning the tool to the magazine:
Select Set T, S, F (can only be selected in
Machine mode of operation)
Select Return tool to the magazine
Return the tool to the magazine with the Save
soft key
Unloading the magazine:
Select Set T, S, F (can only be selected in
Machine mode of operation)
Select Unload magazine
Select the tool
Press the Unload soft key
Remove the tool from the magazine list with the
Save soft key
To Next Page
Loading...
