Machine mode of operation | Pocket table setup
4
120
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Resetting the tool life in the turret list
Resetting the tool life:
Select Set T, S, F (can only be selected in
Machine mode of operation)
Press the Turret list soft key
Press the Special functions soft key
Press the Set teeth to new soft key
Press the YES soft key to confirm the
confirmation prompt
Press the Back soft key
Resetting the tool life in the magazine list
Resetting the tool life:
Select Set T, S, F (can only be selected in
Machine mode of operation)
Select Tool change
Press the Magazine list soft key
Select the tool
Press the Edit the tool soft key
Press the New tooth soft key
Press the Back soft key
To Next Page
Loading...
