Fundamentals | Software and features
16
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
The parameter C was added to G808,
see the smart.Turn and DIN Programming User's Manual
The parameter U was added to G810 and G820,
see the smart.Turn and DIN Programming User's Manual
The parameter D was added to G4 and G860,
see the smart.Turn and DIN Programming User's Manual
The parameter B was added to G890,
see the smart.Turn and DIN Programming User's Manual
The parameter RB was added to the units G840 "Contour
milling, figures" and G84X "Pocket milling, figures",
see the smart.Turn and DIN Programming User's Manual
The parameters SP and SI were added to all tapping units,
see the smart.Turn and DIN Programming User's Manual
G48 was introduced to allow limiting the
rapid traverse rate for rotary and linear axes,
see the smart.Turn and DIN Programming User's Manual
G53, G54, and G55 were introduced
for zero-point shifts using offset values,
see the smart.Turn and DIN Programming User's Manual
The functions for superimposing axis movements
Eccentric turning G725, Eccentric transition
G726, and Non-circular X G727 were introduced,
see the smart.Turn and DIN Programming User's Manual
The load monitoring functions G995 "Monitoring zone
definition" and G996 "Type of load monitoring" were introduced,
see the smart.Turn and DIN Programming User's Manual
The AWG submode now also supports
tools with quick-change tool holders,
see the smart.Turn and DIN Programming User's Manual
A tree view is available in the smart.Turn operating mode,
see the smart.Turn and DIN Programming User's Manual
Skip levels can be defined in the smart.Turn operating mode,
see the smart.Turn and DIN Programming User's Manual
A function was introduced to output information on the tool
status, see the smart.Turn and DIN Programming User's Manual
To Next Page
Loading...
