Fundamentals | Software and features
18
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Programming with variables in the smart.Turn
operating mode is now possible with soft keys,
see the smart.Turn and DIN Programming User's Manual
The number of local variables was increased from 30 to 99,
see the smart.Turn and DIN Programming User's Manual
In the NC program, the status of shifts G920/G921
can now be queried with the variables #n920(G),
see the smart.Turn and DIN Programming User's Manual
In the smart.Turn operating mode, the number of an
M function can now also be defined with a variable
see the smart.Turn and DIN Programming User's Manual
In the smart.Turn operating mode, up
to four contour groups are supported,
see the smart.Turn and DIN Programming User's Manual
In a program generated in the AWG submode, the tool traverses
to the tool change position after the parting working step,
see the smart.Turn and DIN Programming User's Manual
In a program generated in the AWG submode, machining is
now also possible with simplified geometry programming,
see the smart.Turn and DIN Programming User's Manual
The TURN PLUS function can now also be used in INCH mode,
see the smart.Turn and DIN Programming User's Manual
The CW parameter was changed into a user
prompt: Reverse the tool 0: No 1: Yes,
see the smart.Turn and DIN Programming User's Manual
The Q parameter in G99 is supported,
see the smart.Turn and DIN Programming User's Manual
The DO parameter was added to the G860 Contour
recess in ICP and G860 Contour recess, direct cycles.
see the smart.Turn and DIN Programming User's Manual
The Type of tool access" parameter can now also be modified
via the machining parameters in the smart.Turn operating
mode, see the smart.Turn and DIN Programming User's Manual
The G154 Short path in C function was introduced,
see the smart.Turn and DIN Programming User's Manual
The parameter O Flow was added to G741,
see the smart.Turn and DIN Programming User's Manual
Parameter A of G845 has been enhanced with the input
option for pilot drilling in the reference point of the figure,
see the smart.Turn and DIN Programming User's Manual
The input range for Boring depth in
the G74 drilling cycle was expanded,
see the smart.Turn and DIN Programming User's Manual
No error message is displayed anymore in the
paraxial turning cycles if the task is to be carried
out with the secondary cutting edge of the tool,
see the smart.Turn and DIN Programming User's Manual
Machining parameters are displayed in millimeters or inches
according to the CfgUnitOfMeasure parameter (101100)
To Next Page
Loading...
