Teach-in | Turning cycles
5
202
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Cycle run:
1 Calculate the proportioning of cuts (infeed)
2
Approach the workpiece from the Start point for the first pass
3
Move to the End point contour X2 at the programmed feed
rate
4
The contour is machined according to the setting in Contour
smoothing H
5 Retract and approach for the next pass
6
Repeat 3 to 5 until the Start point contour Z1 is reached
7
Return to the Start point on a diagonal path
8
Move to the Tool change point according to the setting in G14
To Next Page
Loading...
