Teach-in | Recessing cycles
5
266
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Cycle run:
1 Calculate the recess positions
2 Approach the workpiece for the next recess on a paraxial path
from the Start point or from the last recess
3 Finish the first side and the contour valley up to a position just
before the recess end point
4 Approach the workpiece on a paraxial path for finishing the
second side
5 Finish the second side and the remainder of the contour valley
6 Repeat 2 to 5 until all recesses have been machined
7
Return to the Start point on a paraxial path
8
Move to the Tool change point according to the setting in G14
To Next Page
Loading...
