HEIDENHAIN 548431-05 - Page 28

Contents
28
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
4 Machine mode of operation..........................................................................................................91
4.1 Machine mode of operation............................................................................................................... 92
4.2 Switch-on / Switch-off.........................................................................................................................93
Switch-on................................................................................................................................................93
Monitoring EnDat encoders...................................................................................................................93
Reference submode...............................................................................................................................94
Switch-off................................................................................................................................................95
4.3 Machine data........................................................................................................................................ 96
Input of machine data............................................................................................................................96
Machine-dependent variants of the TSF dialog..................................................................................... 98
Machine data display........................................................................................................................... 102
Cycle states..........................................................................................................................................106
Axis feed rate.......................................................................................................................................106
Spindle..................................................................................................................................................107
4.4 Pocket table setup............................................................................................................................. 108
Machine with tool holder (Multifix)......................................................................................................108
Machine with turret..............................................................................................................................109
Machine with magazine....................................................................................................................... 110
Filling the turret list with contents from the tool list...........................................................................111
Editing the turret list............................................................................................................................ 113
Editing the magazine list......................................................................................................................115
Tool call.................................................................................................................................................117
Driven tools.......................................................................................................................................... 118
Tools in different quadrants..................................................................................................................118
Tool life monitoring...............................................................................................................................119
4.5 Machine setup.................................................................................................................................... 121
Defining the workpiece datum............................................................................................................ 121
Defining offsets....................................................................................................................................122
Axis reference run................................................................................................................................122
Setting the protection zone................................................................................................................. 123
Defining the tool change position........................................................................................................124
Setting C-axis values............................................................................................................................125
Setting up machine dimensions...........................................................................................................126
Calibrating the tool touch probe.......................................................................................................... 126
Displaying operating times...................................................................................................................127
Configuring the HR 550FS wireless handwheel..................................................................................128
Setting the system time...................................................................................................................... 131
4.6 Tool measurement............................................................................................................................. 132
Touch-off............................................................................................................................................... 133
Touch probe (tool touch probe)............................................................................................................134