Teach-in | Recessing cycles
5
282
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Cycle run:
1 Calculate the proportioning of cuts
2
Approach the workpiece from the Start point for the first pass
3 Execute the first cut (recessing)
4 Machine perpendicularly to the recessing direction (turning)
5
Repeat 3 to 4 until the End point contour X2, Z2 is reached
6
Return to the Start point on a paraxial path
7
Move to the Tool change point according to the setting in G14
To Next Page
Loading...
