Teach-in | Recessing cycles
5
288
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Cycle run:
1
Approach the workpiece from the Start point on a paraxial path
2 Finish the first side and the contour area up to a position just
before the End point contour X2, Z2
3
Move to the Start point X/End point contour Z2 on a paraxial
path
4 Finish the second side, then finish the remainder of the contour
valley
5
Return to the Start point on a paraxial path
6
Move to the Tool change point according to the setting in G14
To Next Page
Loading...
