HEIDENHAIN 548431-05 - Page 30

Contents
30
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
5 Teach-in..........................................................................................................................................171
5.1 Working with cycles.......................................................................................................................... 172
Cycle starting point.............................................................................................................................. 172
Help graphics....................................................................................................................................... 173
DIN macros.......................................................................................................................................... 173
Graphical test run (simulation)............................................................................................................. 173
Contour follow-up in Teach-in submode...............................................................................................174
Cycle keys............................................................................................................................................ 174
Switching functions (M functions)....................................................................................................... 175
Comments............................................................................................................................................175
Cycle menu.......................................................................................................................................... 176
Tool compensation in Teach-in submode.............................................................................................179
Addresses used in many cycles.......................................................................................................... 180
5.2 Workpiece blank cycles..................................................................................................................... 181
Bar/tube blank...................................................................................................................................... 181
ICP workpiece blank contour...............................................................................................................182
5.3 Single cut cycles................................................................................................................................ 183
Rap. trav. positioning............................................................................................................................184
Approaching the tool change position................................................................................................. 185
Linear mach. longit...............................................................................................................................186
Transv. linear maching.......................................................................................................................... 187
Linear machining in angle.................................................................................................................... 188
Circular machining................................................................................................................................ 190
Chamfer................................................................................................................................................192
Rounding.............................................................................................................................................. 194
M functions..........................................................................................................................................196
5.4 Turning cycles..................................................................................................................................... 197
Tool position......................................................................................................................................... 198
Cut longitud..........................................................................................................................................199
Cut transv............................................................................................................................................. 201
Cut longitud.—Expanded......................................................................................................................203
Cut transv.—Expanded.........................................................................................................................205
Finishing cut longitud...........................................................................................................................207
Finishing cut transv.............................................................................................................................. 209
Finishing cut longitud.—Expanded.......................................................................................................211
Finishing cut transv.—Expanded..........................................................................................................213
Cutting, longitudinal plunge..................................................................................................................215
Cutting, transverse plunge...................................................................................................................217
Cutting, longitudinal plunge—Expanded.............................................................................................. 219
Cutting, transverse plunge—Expanded................................................................................................221
Longitudinal cutting, finishing plunge.................................................................................................. 223
Traverse cutting, finishing plunge........................................................................................................ 225
Longitudinal cutting, finishing plunge—Expanded............................................................................... 227