Teach-in | Recessing cycles
5
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
307
Cycle run:
1 Calculate the proportioning of cuts
2
Approach the workpiece from the Start point to the safety
clearance
3
Move at the programmed feed rate to the Undercut diameter I
and dwell at this position (for two revolutions)
4 Retract and approach for the next pass
5
Repeat 3 to 4 until the Contour corner Z1 is reached
6 After the last pass, finish the adjoining plane surface, starting
from End point transv. X2, if defined
7 Machine the chamfer or rounding arc, if defined
8
Return to the Start point on a diagonal path
9
Move to the Tool change point according to the setting in G14
To Next Page
Loading...
