Teach-in | Recessing cycles
5
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
309
Cycle run:
1
Approach the workpiece from the Start point to the Safety
clearance
2 Cut to the depth of the chamfer or rounding and machine the
chamfer/rounding if defined
3 Depending on the cycle parameters, move at the programmed
feed rate to
The turning center, or
The Inner diameter (pipe) XE
If you have programmed a feed-rate reduction, the control
switches to the Reduced feed E as soon as the tool reaches
the Diam. feed reduction I.
4
Retract at the end face and return to the Start point
5
Move to the Tool change point according to the setting in G14
The limit to the Maximum speed D is only effective in
the cycle. After the cycle ends, the speed limit before
the cycle becomes effective.
To Next Page
Loading...
