Teach-in | Thread and undercut cycles
5
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
341
Internal thread and thread undercut
The machining operation consists of two steps. The Undercut DIN
76 cycle machines the undercut and thread chamfer. The thread
cycle then cuts the thread.
1st step
The parameters for the undercut and thread chamfer can be
programmed in two superimposed input windows.
The control determines the undercut parameters from the standard
table.
For the thread chamfer, you only need to enter the chamfer width.
The angle of 45° is the default value for the Cut-in angle WB.
Tool data:
Turning tool (for internal machining)
TO = 7 – Tool orientation
A = 93° – Tool angle
B = 55° – Point angle
2nd step
The thread cycle (longitudinal) cuts the thread. The thread pitch
is defined. The control automatically determines all other values
from the standard table.
You must pay attention to the setting of the Inner thread soft key.
Tool data:
Turning tool (for internal machining)
TO = 7 – Tool orientation
To Next Page
Loading...
