Teach-in | Drilling cycles
5
356
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
HC: Shoe brake (machine-dependent)
DF: Miscellaneous function (machine-dependent)
Type of machining for technology database access:
Tapping
Cycle run:
1
Position the spindle to the Spindle angle C (in Machine mode:
machining from current spindle angle)
2
If defined, move at rapid traverse to the Start point drill X1
3
Tap the thread to the End point drill X2
4
Retract at Return speed SR
If X1 is programmed, to Start point drill X1
If X1 is not programmed, to Start point X
5
Move to the Tool change point according to the setting in G14
To Next Page
Loading...
