Teach-in | Drilling cycles
5
358
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
WP: No. of spindle – Displays which workpiece spindle is used
to execute the cycle (machine-dependent)
Main drive
Opposing spindle for rear-face machining
BW: Angle in the B axis (machine-dependent)
CW: Reverse the tool (machine-dependent)
HC: Shoe brake (machine-dependent)
DF: Miscellaneous function (machine-dependent)
Type of machining for technology database access:
Milling
Cycle run:
1
Position the spindle to the Spindle angle C (in Machine mode:
machining from current spindle angle)
2
Position the tool to the End point drill Z2 (milling floor) inside
the hole
3
Approach on Approach radius R
4 Mill the thread in a rotation of 360°, while advancing by the
Thread pitch F1
5
Retract the tool and return it to the Start point
6
Move to the Tool change point according to the setting in G14
To Next Page
Loading...
