Teach-in | Milling cycles
5
364
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Cycle run:
1
Activate the C axis and position at Spindle angle C at rapid
traverse (only in Teach-in submode)
2 Calculate the proportioning of cuts
3
Approach at Approach feed FZ
4
Machine to the end point of slot
5
Approach at Approach feed FZ
6
Machine to the starting point of slot
7 Repeat 3 to 6 until the milling depth is reached
8
Position to the Start point Z and deactivate the C axis
9
Move to the Tool change point according to the setting in G14
To Next Page
Loading...
