Teach-in | Milling cycles
5
368
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
G14: Tool change point
Further information: "Tool change point G14", Page 180
ID: ID no.
S: Cutting speed or Constant speed
F: Feed per revolution
I: Contour-parallel oversize
K: Infeed-direction oversize
P: Feed depth (default: total depth of one infeed)
FZ: Approach feed (default: active feed rate)
E: Reduced feed for circular elements (default: active feed rate)
O: Roughing/Finish – Only for pocket milling
0: Roughing
1: Finishing
H: Mill cutting direction
0: Up-cut
1: Climb
U: Overlap factor – defines the overlap of milling paths (default:
0.5) (range: 0 to 0.99)
Overlap = U * milling diameter
U = 0 or no input: Contour milling
U > 0: Pocket milling – Minimum overlap of milling paths = U
* milling diameter
JK: Contour milling – Input is evaluated only for contour milling
0: On the contour
1: Within the contour
2: Outside the contour
JT: Pocket milling – Input is evaluated only for pocket milling
0: From the inside out
1: From the outside in
R: Apprch angle (default: 0)
R = 0: Contour element is approached directly; infeed to
starting point above the milling plane—then vertical plunge
R > 0: Tool moves on approaching/departing arc that
connects tangentially to the contour element
R < 0 for inside corners: Tool moves on approaching/
departing arc that connects tangentially to the contour
element
R < 0 for outside corners: Length of linear approaching/
departing element; contour element is approached/departed
tangentially
To Next Page
Loading...
