ICP programming | Contour elements – turning contour
6
458
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Undercut form K
Programming an undercut form K:
Select the form elements
Select Undercut form K
Enter the undercut parameters
Parameters:
I: Undercut depth
R: Undercut radius
W: Opening angle
A: Plunging angle
U, F, D, DF:
Further information: "Machining attributes", Page 418
ICP generates a G25 in smart.Turn mode of operation.
Undercuts can be programmed only between two linear
elements. One of the two linear elements must be
parallel to the X axis.
To Next Page
Loading...
